When used in a jet liquefier with a steam pressure of ≥0.6Mpa , the jet liquefaction process can fully form a high-strength micro-turbulent flow, and the starch has good dispersibility and liquefaction. Feed pump and low head requirements, low energy consumption. High purity, no insoluble starch granules, good protein flocculation effect, and saccharification solution with separation effect of starch and protein has been achieved. By jet liquefaction, significant protein together, floating on the liquid surface, sugar filters much faster. Since the gap is eliminated, the dextrin is caused by the uneven heating of the saccharified solution to liquefy the material, and it is difficult to change the coagulated protein, the sugar is difficult to filter, and the fermentation of the protein, dextrin-based mixed sugar solution, resulting in foam increases, serious fluid Escape, production conditions and the quality of the post-purification liquid affect the extraction rate during purification. Continuous jet liquefaction without blocking. Blockage is completely eliminated from the structure's high pressure steam jet liquefaction principle. With the lower concentration of all or rice starch in the slip ≥22Be box, the blockage cannot be observed from the manufacturer when used, jet liquefaction cleaning without disassembly within 2 years. Eliminate defects made in the past due toThe liquefaction injector nozzle diameter, etc., especially with superheated steam injection, usually cannot be blocked for continuous production. The high-pressure steam used for the steam jet liquefaction bar is used together, the driving force is high-pressure steam, the high-pressure steam to drive the liquefied material is more uniform and sufficient, and further energy saving, due to the low feed pump head requires production costs again.

The automatic high-pressure steam jet liquefier is a complex heat transfer equipment, which can ensure long-term normal operation under various working environments, accurate, fast, stable heating, and convenient operation . The domestic pneumatic membrane driver is used for automatic control.

According to long-term market research, due to the high sand content of cassava and other raw materials, serious nozzle wear and short service life of production equipment, our factory specially designed and developed a full range of high-quality wear-resistant high-pressure steam jet liquefier models. The wear-resistant parts are made of cemented carbide. , so as to fundamentally solve the problem of wear and tear and prolong the service life of the equipment, and manufacturers are welcome to choose them in a targeted manner.

Product use precautions

When steam inlet jet liquefaction is required, the delivery fluid inlet valve is required to be installed vertically. As shown in Figure 2, in the steam jet liquefaction chamber, a 0-1Mpa gauge liquid feed chamber is installed. Install an electronic thermometer at the 0-150°C thermometer interface. 3. In order to avoid the entanglement of the nozzle rope of the liquefaction injector and the blockage of other debris, it should be added when the basket is slurried into a slag tank (14 mesh-16 mesh/inch). As shown in Figure 4, when the high temperature working pressure is greater than 0.4MPa, the starch milk feed pump is concentrated. As shown in Figure 5, the device is suitable for 30-40% starch slurry concentration. The desired enzyme preparation can be added according to process requirements and pH value adjustment. As shown in Figure 6, the steam regulating valve and inlet valve, the outlet temperature required for the liquefaction process. 7. After the rinsing jet liquefaction jet is applied, it is still clean.